Desktop SoftwareJust In

Tempo Dynamics Ableton Live Pack Is New & FREE For A Limited Time

Isotonik Studios have released Tempo Dynamics, available as a FREE download for a limited time, increasing to £10.00 after the promotion. The offer ends March 12th.

When applying dynamic effects, we are rarely going to need the entire timing ranges available, depending on the tempo, right? The Tempo Dynamics Ableton Live Pack provides go-to racks with minimum and maximum values hard-wired to ranges most potentially useful, given the chosen tempo — avoiding values that are likely too fast or too slow to be helpful.

Want to limit, squish, groovify, level, expand, or gate something?

Reach for one of these racks in the nearest available tempo, and with handy knobs available to fine-tune, then dial it in quickly without worrying about the numbers or graphs… all while retaining the human element of your personal touch still in place.

The macro knobs are also useful for automating in an arrangement, say to let something breathe more during one section and then clamp down during another.

The macro knobs are also useful for automating in an arrangement, say to let something breathe more during one section and then clamp down during another.

What’s included:

  • Tempo Compressors – ranging from 20 to 240 bpm in 10bpm increments.
  • Tempo Expanders – ranging from 25 to 235 bpm in 15bpm increments
  • Tempo Gates – ranging from 30 to 240 bpm in 30bpm increments.
  • Tempo Gluers – ranging from 20 to 240 bpm in 20bpm increments
  • Tempo Limiters – ranging from 20 to 240 bpm in 10bpm increments.

Tempo Compressors

Generally known for decreasing dynamic range, by adjusting the settings carefully, you can also acheive a sort of “reactive dance” feeling, which is more about imparting a sense of groovy movement.


  • Push – squeezes the threshold down, increasing potential compression. Adjusting this carefully is paramount.
  • Low End Punch – restores bass that may have been overly squashed, since low frequencies can tend to peak higher and eat up more headroom than others.
  • Level-Groove-Squish? – selects mode:
    • Level is for overall, gradual smoothing. Might be good for pads, ambient soundscapes, or live broadcast.
    • Groove is for enhancing a sense of “3D life” by symbiotically responding to the integral vibe.
    • Squish is for your typical reduction of dynamic range by curtailing too-loud moments.
  • Breathe vs Clamp – is your one-knob timing control, allowing transients to breathe more or less. Adjust it by feel.
  • Makeup Gain – is for adjusting the level of the compressed signal (pre dry-wet).
  • Dry/Wet%  makes it easy to implement in parallel and automate the amount.
  • To see the compression display, click “Show/Hide Devices” to unfold, then click the “Auto Select” arrow.

Tempo Expanders

The opposite of a compressor, an expander reacts to the same trigger signal, but instead of squeezing down on material that exceeds the threshold, it boosts those moments even more. Can be useful for re-invigorating overly flattened material, or to boost punchiness with minimal increase to the ambient noise floor.


  • Pull – stretches the threshold down, increasing potential expansion. Increase loudness without boosting the ambient noise floor.
  • Attack v Sustain -is your one-knob timing control, allowing to focus more or less on enhancing either the intial sharp transient, or the sustain that happens immediately thereafter.
  • Makeup Gain – in this case, you’ll generally be pulling it DOWN to level-match to the dry signal, rather than up.
  • Dry/Wet% – does that. Y’know.

Tempo Gates

That annoying noise in-between note hits, where it’s supposed to be silent. Pretend it doesn’t exist. Gate it.


  • Gate – does that thing. The higher you lift it, the more stuff won’t be able make it through the gate.
  • Maintain – allows more material to get through a triggered gate.
  • Soothe – rounds off the behavior of the gating action, making it less choppy and more soft overall.
  • Makeup Gain – is not usually necessary when using gates, but if you’re chopping out a lot of energy you might want to boost the average up a little to make up for it.

Tempo Gluers

“Pick, Drop, Push, & Blend”

Despite its distinction as classic “buss” style compressor, they are used on individual tracks all the time, due to their ease-of-implementation thanks to the stepped controls and generally tasteful, refined sound.

You don’t even have to think about the timing controls for these. Just pick a tempo, drop the rack in, push it, gainstage it, and blend it. Done.


  • Push – squeezes the threshold, increasing potential compression.
  • SoftClip Output? – to more aggressively limit the output, if desired or needed.
  • Makeup Gain – you know what that is for. At least you should by now.
  • Dry/Wet% – yep mmhmmm.

Tempo Limiters

For these, the lookahead is based on the tempo, but the release is highly adjustable. Fairly fast default release times are given, but the adjustable range for each is quite versatile. Slower release times can lead to a cleaner (but not as loud) end result.


  • Push – increases maximum potential limiting.
  • Recover – determines how soon limiting stops after being engaged. A longer recovery time will result in a cleaner, more polite sound; a shorter recovery will result in a louder, more aggressive sound.
  • Stereo Link – can be turned off if desired, but that can result in some unnatural streo fluttering when wide-panned transients are mixed with sustained sounds. When to unlink? Probably not on busses or the master channel, but perhaps for certain types of stereo recordings, for instance an L-R mic pair that is somewhat dynamically off-balance.
  • Makeup Gain – needs no explination.

Tempo Dynamics requires Ableton Live 10.1.9+ or Live 11.

For more information and to download Tempo Dynamics, click here: 

NOTE: Some of the links you click on may be affiliated. Clicking and purchasing using these links helps support and fund The Beat Community. Thanks for your support.

Tags: , , , , , , ,

More Similar Posts

Recent Posts